pastertwin.blogg.se -

#TRIMBLE PATHFINDER SOFTWARE USER ACTIVATION CODE#
#TRIMBLE PATHFINDER SOFTWARE USER UPDATE#

To change to a new satellite frequency that may not be in the EZ SAT list, follow the instructions below: To change to a satellite frequency that already exists in the EZ SAT list, follow the instructions above for Activation Set-up. The second line should display the DGPS satellite frequency. THE letter G will be replaced as a D when the receiver starts computing differentially corrected positions. The HOME SCREEN will display on the top line, the type of position recorded.Use ENTER key to scroll through the screens for status of the OmniStar subscription activation noting USER ENABLED and STOP DATE.Press DOWN ARROW key until Omni*SERVICE INFO appears.Press DOWN ARROW key and screen should display AGE of DGPS and AGE of SYNC.Press DOWN ARROW key and DGPS DATA SOURCE should read correct REFERENCE STATION ID.Press DOWN ARROW key and screen should display Omni as SERVICE PROVIDER.First screen should display Satellite Frequency and S/N of the satellite signal-noise ratio and the strength of the differential satellite lock.Use RIGHT ARROW key, access the DGPS SCREEN.From the HOME SCREEN press the RIGHT ARROW key until you access the STATUS screen.It is important that the system be left on until the receiver positions differentially. It can take up to 30 minutes for activation to be complete. When received, it will display RESET BY OMNI ACTIVATION, PLEASE HIT ENTER TO CONTINUE.

#TRIMBLE PATHFINDER SOFTWARE USER ACTIVATION CODE#

OmniSTAR must then send an activation code (RSOC-type) over the satellite to the unit.

Allow 30-45 minutes to get the system to work during the activation process.

The program will reply an error message: “Lost communications with the receiver check cables”.

After changing the frequency, restore the settings of Port A to Port output NMEA baudrate 9600,8,N,1.

Press DOWN ARROW key until prompted to exit DGPS CONFIG.

#TRIMBLE PATHFINDER SOFTWARE USER UPDATE#

This should update to the Data Rate of the satellite you specified in the EZ SAT: field.

Press DOWN ARROW key until SATELLITE BAUD RATE screen appears.

This will list the frequency of the DGPS satellite you specified in the EZ SAT: field.

Press DOWN ARROW key until SATELLITE FREQ screen appears.

For a list of satellite frequencies, click here.

Use arrow keys to choose the correct satellite for your area.

Press DOWN ARROW key until EZ SAT: screen appears.

Press DOWN ARROW key until DGPS SOURCE screen appears.

Press RIGHT ARROW key until you access the DGPS CONFIGURATION screen.

Press DOWN ARROW key to enter these screens.

From the HOME SCREEN press the RIGHT ARROW key until you access the CONFIGURATION screen.

Use AgRemote, after connecting to the receiver the rest of the procedure is the same as the Trimble Ag132 above.

Use the AgRemote program ( available here) to set up your Ag114 receiver for your OmniSTAR activation.

For additional information, please refer to Trimble’s website. Technical information for many of these receivers can be found by selecting More below. Trimble Construction receivers that support OmniSTAR services include the following: Technical information is available here for the following Trimble Pathfinder receivers:įor information about other Trimble Mapping & GIS receivers, please visit the Trimble website at Construction Receivers For additional information, please refer to Trimble’s website at Mapping / GIS Receivers Technical information for many of these receivers can be found below. Trimble Agriculture receivers that support OmniSTAR services include the following: